1995 Toyota Avalon Keyless Entry Remote Fob Programming Guide

Important Notice: A maximum of two remotes can be programmed to this vehicle. Programming a new remote will erase all previously stored remotes, so both must be programmed during the same session if needed.

Programming Procedure:

• Step 1: Ensure the Key Is Removed Begin with the ignition key fully removed from the ignition switch.
• Step 2: Access the Bulb Failure Warning Module Open the trunk and locate the bulb failure warning module near the left-hand hinge. Disconnect the multi-pin connector attached to the module.
• Step 3: Enter Programming Mode Using a jumper wire, connect terminals 2 and 10 on the disconnected harness plug. The system should automatically respond by locking and unlocking the doors once and activating the trunk release—this confirms entry into programming mode.
• Step 4: Program the First Remote Press any button on the first remote. The vehicle should again lock and unlock the doors and activate the trunk release to confirm successful programming.
• Step 5: Program the Second Remote (If Applicable) Within a few seconds, press any button on the second remote. The system will once more lock and unlock the doors and activate the trunk release to confirm successful programming.
• Step 6: Exit Programming Mode Remove the jumper wire from the connector and reconnect the multi-plug to the bulb failure warning module.
• Step 7: Test All Programmed Remotes Verify that each remote performs the lock, unlock, and trunk functions properly.

Additional Notes:

• A maximum of two remotes can be programmed. Programming a remote overwrites all previously stored remotes, so both remotes must be programmed together if more than one is being used.