<h1>1996 Honda Del Sol – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b> Important Note:</b> Entering programming mode will erase all previously stored remote codes. This means you must reprogram every remote you wish to use with the vehicle during this session. To avoid the system exiting programming mode prematurely, each step must be completed within five seconds of the previous one. </font></p> <p><b><font size="3">Programming Steps:</font></b></p> <ul> <li><font size="3"> Step 1: Insert the key into the ignition and turn it to the ON (II) position. Do not start the engine. </font></li> <li><font size="3">Step 2: Press either the LOCK or UNLOCK button on the remote you wish to program. Note: A new, unprogrammed remote may be used for this step.</font></li> <li><font size="3"> Step 3: Turn the ignition back to the LOCK (0) position. </font></li> <li><font size="3">Step 4: Repeat Steps 1 through 3 two more times (for a total of three cycles), using the same remote each time. This means: ON → press LOCK/UNLOCK → OFF — three times in a row.</font></li> <li><font size="3"> Step 5: After the third cycle, turn the ignition to the ON (II) position again. You should now be in programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote again. The door locks should cycle (lock then unlock) to indicate the system has entered programming mode. </font></li> <li><font size="3">Step 7: Within five seconds, press the LOCK or UNLOCK button on each remote you wish to program. After each button press, wait for the door locks to cycle, which confirms the remote has been accepted. </font></li> <li><font size="3">Step 8: Once all remotes have been programmed, turn the ignition back to the LOCK (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test each remote to ensure it controls the door locks as expected.</font></li> </ul>
