1996 Nissan 200SX

1996 Nissan 200SX – Keyless Entry Remote Fob Programming Instructions

Important Note: All keyless entry remotes must be programmed during the same session. Once the vehicle enters programming mode, previously stored remote codes will be erased.

Programming Steps:

  • Step 1: Sit in the driver’s seat and ensure all doors are closed. Use the power lock switch on the driver’s door to lock all doors.
  • Step 2: Insert the key into the ignition and remove it six times within 10 seconds. Do not turn the key during this step. The tail lamps will flash, confirming that the system has cleared old remote codes and is ready for programming.
  • Step 3: Insert the key once more and turn it to the ACC (Accessory) position.
  • Step 4: Press the LOCK button on the first remote fob. The tail lamps will flash again to confirm successful registration.
  • Step 5: To program additional remotes, use the power lock switch to unlock and then relock the doors. ]
  • Step 6: Press the LOCK button on the next remote. The tail lamps will flash again, confirming that the remote has been programmed.
  • Step 7: Once all remotes are programmed, open the driver’s door and turn the ignition to the “OFF” position to exit programming mode.