<h1>Programming Procedure for 1997 TL Remote Keyless Entry Fob Important</h1> <p><font size="3"><b>Notes:</b> Entering programming mode will erase all previously stored remotes. All remotes must be reprogrammed during the same session. Each step must be completed within 4 seconds of the previous one to avoid exiting programming mode. You must program each additional remote within 10 seconds of the last one. </font></p> <p><font size="3"><b>Step-by-Step Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. </font></li> <li><font size="3">Step 2: Within 4 seconds, press the LOCK or UNLOCK button on one remote. (This can be a new or previously programmed remote.) </font></li> <li><font size="3">Step 3: Within 4 seconds, turn the ignition switch to the OFF (0) position. </font></li> <li><font size="3">Step 4: Within 4 seconds, turn the ignition switch back to ON (II). </font></li> <li><font size="3">Step 5: Repeat Steps 2 through 4 two more times, using the same remote. </font></li> <li><font size="3">Step 6: Within 4 seconds, press the LOCK or UNLOCK button on the same remote again. The door locks should cycle to indicate that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: Within 10 seconds, press the LOCK or UNLOCK button on the same remote to store it. </font></li> <li><font size="3">Step 8: Within 10 seconds of each other, press the LOCK or UNLOCK button on any additional remotes to be programmed (up to three total). Confirm that the door locks cycle after each remote is accepted. </font></li> <li><font size="3">Step 9: Turn the ignition switch to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 10: Test all remotes to ensure they operate as expected.</font></li> </ul>
