<h1>1997 Honda CR-V – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b> Important Notice:</b> Entering programming mode will erase all previously stored remote codes. As a result, all remotes must be reprogrammed during the same session, including any that were already working. Each step must be completed within five seconds of the previous one to maintain programming mode. Delays will cancel the process and require a restart. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON (II) position. Do not start the engine. </font></li> <li><font size="3">Step 2: Press either the LOCK or UNLOCK button on one remote. Note: A remote that hasn’t been programmed before can be used for this step. </font></li> <li><font size="3">Step 3: Turn the ignition switch to the LOCK (0) position. Step 4: Repeat Steps 1, 2, and 3 two more times using the same remote. You should perform these steps a total of three cycles.</font></li> <li><font size="3"> Step 5: After completing the third cycle, turn the ignition to the ON (II) position once again.</font></li> <li><font size="3"> Step 6: Press the LOCK or UNLOCK button on the same remote used earlier. The door locks should cycle (lock and unlock) automatically to confirm the vehicle has entered programming mode.</font></li> <li><font size="3"> Step 7: Within programming mode, press the LOCK or UNLOCK button on each remote you wish to program. After pressing each button, the door locks should cycle to confirm that the system has accepted the remote. </font></li> <li><font size="3">Step 8: Turn the ignition switch to the LOCK (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test all programmed remotes to ensure proper operation.</font></li> </ul>
