<h1>1997 Honda Del Sol – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> Activating programming mode will erase all previously stored remotes. You must reprogram every remote you want to use during the same session. To maintain access to programming mode, each step must be completed within 5 seconds of the previous step.</font></p> <p><b><font size="3"> Programming Procedure:</font></b></p> <ul> <li><font size="3"> Step 1: Insert the key into the ignition and turn it to the ON (II) position without starting the engine. </font></li> <li><font size="3">Step 2: Press either the LOCK or UNLOCK button on the remote. Note: A new or previously unprogrammed remote may be used for this step. </font></li> <li><font size="3">Step 3: Turn the ignition switch back to the LOCK (0) position. </font></li> <li><font size="3">Step 4: Repeat Steps 1 through 3 two more times (for a total of three cycles), using the same remote. ON (II) → press LOCK/UNLOCK → OFF (0) Repeat this cycle three times. </font></li> <li><font size="3">Step 5: After completing the third cycle, turn the ignition to the ON (II) position again. The system should now be in programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote once more. The power door locks should cycle (lock then unlock) to confirm you’ve successfully entered programming mode. </font></li> <li><font size="3">Step 7: Within five seconds, press the LOCK or UNLOCK button on each remote you wish to program. The door locks should cycle after each button press, confirming the system has recognized and accepted each remote. </font></li> <li><font size="3">Step 8: Turn the ignition switch back to LOCK (0) to exit programming mode. </font></li> <li><font size="3">Step 9: Test all remotes to ensure proper operation of the lock and unlock functions.</font></li> </ul>
