<h1>Keyless Entry Remote Programming Instructions – 1997 Honda Prelude</h1> <p><font size="3"><b>Important Notice:</b> When you enter programming mode, all previously programmed remotes will be erased. You must reprogram every remote you wish to use during the same session. Each step must be completed within 5 seconds of the previous one, or the system will exit programming mode automatically. </font></p> <p><font size="3"><b>Step-by-Step Programming Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON (II) position. (This is the position just before starting the engine.) </font></li> <li><font size="3">Step 2: Press either the LOCK or UNLOCK button on the remote you are using for programming. A remote that has not been programmed before may be used for this step. </font></li> <li><font size="3">Step 3: Turn the ignition switch back to the OFF (0) position. </font></li> <li><font size="3">Step 4: Repeat steps 1 through 3 two more times (for a total of three cycles) using the same remote. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition to the ON (II) position once again.</font></li> <li><font size="3"> Step 6: Press the LOCK or UNLOCK button on the same remote. The door locks should cycle, confirming that the system is now in programming mode. </font></li> <li><font size="3">Step 7: For each additional remote, press either the LOCK or UNLOCK button once. The door locks should cycle after each successful programming to confirm the system has accepted the remote. </font></li> <li><font size="3">Step 8: Turn the ignition to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test each remote to verify that it is functioning correctly.</font></li> </ul>
