<h1>Programming a Keyless Entry Remote for 1997 Navigator – Step-by-Step Guide</h1> <p><font size="3"><b> Important:</b> This procedure allows you to program keyless entry remote fobs for a 1997 Navigator using the vehicle’s onboard programming mode. A maximum of four remotes can typically be programmed. All remotes must be programmed during the same session. Ensure all existing remotes are available before beginning. Complete each step promptly to stay within timing limits. If programming fails, restart the process from the beginning. Read through the entire procedure before starting. </font></p> <p><font size="3"><b>Remote Fob Programming Steps:</b> </font></p> <ul> <li><font size="3">Step 1: Make sure all vehicle doors are closed. </font></li> <li><font size="3">Step 2: Open the driver’s door and leave it open during the process. </font></li> <li><font size="3">Step 3: On the driver’s door panel, press and hold the UNLOCK button. </font></li> <li><font size="3">Step 4: Insert the key into the ignition while holding the unlock button. </font></li> <li><font size="3">Step 5: Turn the ignition from OFF to RUN (do not start the engine). </font></li> <li><font size="3">Step 6: Repeat the OFF to RUN cycle five times within 10 seconds, ending with the key in the RUN position on the fifth turn. </font></li> <li><font size="3">Step 7: The door locks will cycle (lock and unlock) to indicate the vehicle has entered programming mode. </font></li> <li><font size="3">Step 8: Within 20 seconds, press any button on the first remote fob. </font></li> <li><font size="3">Step 9: The door locks will cycle again to confirm the first remote has been programmed. </font></li> <li><font size="3">Step 10: Within 20 seconds, press any button on the second remote fob (if applicable). </font></li> <li><font size="3">Step 11: The locks will cycle to confirm programming of the second remote. </font></li> <li><font size="3">Step 12: Repeat this step for any additional remotes you wish to program (up to the system’s limit).</font></li> <li><font size="3">Step 13: Once all remotes are programmed, turn the ignition to the OFF position. </font></li> <li><font size="3">Step 14: The door locks will cycle one final time to confirm the end of programming mode. </font></li> <li><font size="3">Step 15: Test all remotes to ensure they lock and unlock the doors properly.</font></li> </ul>
