<h1>Programming Instructions for 1998 TL Remote Keyless Entry Fob Important</h1> <p><font size="3"><b> Notes:</b> Entering programming mode will erase all previously stored remotes. Any remotes you wish to use must be reprogrammed during the same session. Each step must be completed within 4 seconds of the previous one to remain in programming mode. You must program each additional remote within 10 seconds of the previous one. </font></p> <p><font size="3"><b>Step-by-Step Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. </font></li> <li><font size="3">Step 2: Within 4 seconds, press the LOCK or UNLOCK button on one remote. (This may be a new or previously programmed remote.) </font></li> <li><font size="3">Step 3: Within 4 seconds, turn the ignition switch to the OFF (0) position. </font></li> <li><font size="3">Step 4: Within 4 seconds, turn the ignition switch back to ON (II). </font></li> <li><font size="3">Step 5: Repeat Steps 2 through 4 two more times, using the same remote. </font></li> <li><font size="3">Step 6: Within 4 seconds, press the LOCK or UNLOCK button again on the same remote. The door locks should cycle, indicating the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: Within 10 seconds, press the LOCK or UNLOCK button on the same remote again to store it. </font></li> <li><font size="3">Step 8: Within 10 seconds of each other, press the LOCK or UNLOCK button on any additional remotes. The door locks should cycle after each one to confirm successful programming. </font></li> <li><font size="3">Step 9: Turn the ignition switch to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 10: Test all remotes to verify proper function.</font></li> </ul>
