<h1>1998 GMC Safari – Remote Fob Programming Procedure</h1> <p><font size="3"><b>System Type:</b> OBDII Port Programming </font></p> <p><font size="3"><b>Tools Required:</b> Jumper wire </font></p> <p><font size="3"><b>Instructions:</b> To pair a new remote to the 1998 Safari, use the onboard diagnostic port under the dashboard. </font></p> <ul> <li><font size="3">Step 1:Locate the OBDII Port: Found beneath the driver’s side dashboard. Identify terminals 4 and 8 (top row is wider—refer to diagrams if needed). </font></li> <li><font size="3">Step 2:Apply Jumper Wire: Connect terminal 8 to terminal 4 using a wire. Keep the jumper wire connected through the entire process. Once connected, the vehicle should cycle the door locks, indicating it has entered programming mode. </font></li> <li><font size="3">Step 3:Program First Remote: Press and hold both the LOCK and UNLOCK buttons simultaneously on the first remote for approximately 15 seconds. Wait until the doors lock and unlock again to confirm successful programming. </font></li> <li><font size="3">Step 4: Add Additional Remotes: Repeat the same button-holding process for each remote within 60 seconds. </font></li> <li><font size="3">Step 5: Exit Mode: Remove the jumper wire and test each remote for proper functionality.</font></li> </ul>
