<h1>1998 GMC Savana – Keyless Remote Setup Instructions</h1> <p><font size="3"><b>System Type:</b> Standard Keyless Entry via DLC </font></p> <p><font size="3"><b>Manual Programming:</b> Supported </font></p> <p><font size="3"><b>Programming Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Find the OBDII connector under the dash on the driver’s side. </font></li> <li><font size="3">Step 2: Identify pin 8 (top row) and pin 4 (bottom row). </font></li> <li><font size="3">Step 3: Insert a jumper wire between pins 4 and 8. Keep the wire connected for the entire process. </font></li> <li><font size="3">Step 4: The doors should automatically lock and unlock to signal programming mode. </font></li> <li><font size="3">Step 5: Press and hold the LOCK and UNLOCK buttons on the first remote for about 15 seconds. Wait for the locks to cycle again. </font></li> <li><font size="3">Step 6: Repeat Step 5 within one minute for any additional remotes. </font></li> <li><font size="3">Step 7: Remove the jumper wire to exit programming mode. </font></li> <li><font size="3">Step 8: Test all remotes to verify proper operation.</font></li> </ul>
