<h1>1998 Honda Civic Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Requirement:</b> To program a remote for this vehicle, you must have the original factory radio installed and functioning. If an aftermarket radio has been installed, this procedure will not work. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON position. Make sure the engine is off and only the electrical systems are activated. </font></li> <li><font size="3">Step 2: Press and hold the valet button on the factory-installed radio. This button is a skinny bar located between the AM/FM and CD/TAPE buttons on the stock radio. → The door locks will cycle once, indicating that the vehicle is in programming mode. </font></li> <li><font size="3">Step 3: While continuing to hold the valet button, press any button on the remote you wish to program once. This must be done within 20 seconds of the door locks cycling. → The door locks will cycle again, confirming that the remote has been successfully programmed. </font></li> <li><font size="3">Step 4: To program up to 4 additional remotes, repeat Step 3 for each remote. Make sure to continue holding the valet button while programming each additional remote. → After each remote is programmed, the door locks will cycle to confirm successful registration.</font></li> <li><font size="3"> Step 5: Once all remotes are programmed, release the valet button and turn the ignition key to the OFF position. → The programming process is complete. </font></li> <li><font size="3">Step 6: Test each remote by pressing the LOCK and UNLOCK buttons. The vehicle’s door locks should respond by locking and unlocking, confirming that the remotes are functioning as expected.</font></li> </ul>
