<h1>1998 Honda CR-V – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> When entering programming mode, all previously stored remote codes will be erased. You must reprogram every remote fob during the same session, or they will not function. Additionally, each step must be completed within five seconds of the previous one, or the system will exit programming mode automatically. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON (II) position. Do not start the engine. </font></li> <li><font size="3">Step 2: Press either the LOCK or UNLOCK button on one of the remote fobs. Note: You may use a new, unprogrammed remote for this step. </font></li> <li><font size="3">Step 3: Turn the ignition to the LOCK (0) position. </font></li> <li><font size="3">Step 4: Repeat Steps 1 through 3 two more times using the same remote. This means you will perform a total of three cycles. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition to the ON (II) position again. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote used in the previous steps. The power door locks should cycle (lock and unlock), confirming the vehicle is now in programming mode.</font></li> <li><font size="3"> Step 7: Program all remotes by pressing the LOCK or UNLOCK button on each one individually. After pressing the button on each remote, the door locks should cycle to confirm it has been successfully programmed.</font></li> <li><font size="3"> Step 8: Turn the ignition switch to the LOCK (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test all remotes to ensure each one performs the expected functions, including locking and unlocking the doors.</font></li> </ul>
