<h1>1999 Honda Accord Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> Entering programming mode will cancel all previously programmed remotes. Once you enter programming mode, you will need to reprogram all remotes. Ensure that each step is completed within 5 seconds of the previous one to prevent the system from exiting programming mode prematurely. </font></p> <p><b><font size="3">Programming Procedure:</font></b></p> <ul> <li><font size="3"> Step 1: Turn the ignition switch to the ON (II) position, ensuring the vehicle's electronics are powered on but the engine is not running. </font></li> <li><font size="3">Step 2: Press and hold the LOCK or UNLOCK button on the remote. (You can use an un-programmed remote for this step if necessary.)</font></li> <li><font size="3"> Step 3: Turn the ignition switch to the LOCK (0) position, which temporarily disables the vehicle’s electrical systems to prepare for reprogramming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times, using the same remote as in Step 2. Make sure each action is performed within 5 seconds to keep the system from exiting programming mode. </font></li> <li><font size="3">Step 5: Turn the ignition switch back to the ON (II) position. This puts the vehicle into programming mode.</font></li> <li><font size="3"> Step 6: Press the LOCK or UNLOCK button on the same remote used earlier. The power door locks should cycle (lock and unlock) to confirm that the system has successfully entered programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each remote you want to program. After each remote button is pressed, the door locks will cycle, confirming that the system has accepted the remote. </font></li> <li><font size="3">Step 8: Repeat Step 7 for each additional remote that needs to be programmed. Each press should result in the door locks cycling, indicating that the system has successfully learned the remote. </font></li> <li><font size="3">Step 9: Turn the ignition switch to the LOCK (0) position to exit programming mode. This action finalizes the programming process and prevents any further remotes from being added. </font></li> <li><font size="3">Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The door locks should respond by locking and unlocking, confirming that the remotes have been successfully programmed. </font></li> </ul> <p><font size="3"><b>Note:</b> </font></p> <ul> <li><font size="3">If additional features such as panic button or trunk release need to be programmed, refer to the vehicle's owner’s manual or consult a professional for those specific procedures.</font></li> </ul>
