<h1>1999 Honda Civic Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> Entering programming mode will erase all remotes previously paired with the vehicle. You must reprogram all remotes you wish to use during this session. Steps 1–12 must be completed within 5 seconds of each other, or the system will not enter programming mode. Step 13 (programming each remote) must be completed within 10 seconds per remote. A maximum of three remotes can be programmed. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Make sure all doors are unlocked and remain closed throughout the process. This ensures the system is ready to accept new remote signals. </font></li> <li><font size="3">Step 2: Insert the key into the ignition and turn it to the ON (II) position. This activates the vehicle’s electrical system without starting the engine. </font></li> <li><font size="3">Step 3: On the remote you wish to program, press either the LOCK or UNLOCK button once. This sends the first signal to begin synchronization. </font></li> <li><font size="3">Step 4: Turn the ignition to the ACCESSORY (I) or LOCK (0) position. This resets the ignition system before the next input. </font></li> <li><font size="3">Step 5: Quickly turn the ignition back to the ON (II) position. Continue moving through each step without delay. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button again on the same remote. This reinforces the remote’s signal to the vehicle’s system. </font></li> <li><font size="3">Step 7: Turn the ignition to ACCESSORY (I) or LOCK (0) again. Keep the rhythm consistent to maintain eligibility for programming mode.</font></li> <li><font size="3"> Step 8: Turn the ignition once more to the ON (II) position. Avoid pausing too long between each ignition cycle.</font></li> <li><font size="3"> Step 9: Press the LOCK or UNLOCK button on the remote again. This is the third signal confirming remote identity. </font></li> <li><font size="3">Step 10: Turn the ignition to ACCESSORY (I) or LOCK (0). This is the final ignition reset before entering programming mode.</font></li> <li><font size="3"> Step 11: Turn the ignition back to the ON (II) position one last time. This step finalizes the sequence.</font></li> <li><font size="3"> Step 12: Press the LOCK or UNLOCK button on the same remote once again. → If successful, the door locks will cycle (lock then unlock) to confirm that the system is now in programming mode. </font></li> <li><font size="3">Step 13: Now, program all desired remotes one at a time. For each remote: Press the LOCK button once. Wait for the door locks to cycle, confirming successful programming. Repeat for up to three remotes total. → Each remote must be programmed within 10 seconds of the previous one. </font></li> <li><font size="3">Step 14: When all remotes are programmed, turn the ignition to the LOCK (0) position. This exits programming mode and saves the remote settings.</font></li> <li><font size="3"> Step 15: Test each remote to verify operation: Press LOCK and UNLOCK on each fob. Confirm the vehicle’s doors respond correctly to all functions</font></li> </ul>
