<h1>1999 Honda CR-V – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> Entering programming mode will erase all previously programmed keyless remotes. You must reprogram all remotes during the same session, or any that are not included will no longer function. Additionally, to remain in programming mode, each step must be completed within 5 seconds of the previous one. If timing is exceeded, the system will exit programming mode and you will need to start over. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition switch. Turn the ignition to the ON (II) position, but do not start the engine. This powers the electrical systems and initiates the programming sequence. </font></li> <li><font size="3">Step 2: Press either the LOCK or UNLOCK button on one of the remotes. This action signals the system to begin registering a remote. You may use a brand-new, unprogrammed remote for this step.</font></li> <li><font size="3"> Step 3: Turn the ignition switch back to the LOCK (0) position. This completes the first cycle in the registration process. </font></li> <li><font size="3">Step 4: Repeat Steps 1 through 3 two more times, for a total of three full cycles. Use the same remote each time. This repetition confirms to the system that programming mode should be entered. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition switch to the ON (II) position once again. You should now be ready to enter programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote once more. If done correctly and within five seconds, the power door locks will automatically cycle (lock then unlock). This confirms the vehicle has successfully entered programming mode. </font></li> <li><font size="3">Step 7: One at a time, press the LOCK or UNLOCK button on each remote fob you wish to program. Wait for the power door locks to cycle after each press—this confirms the system has accepted the remote. You can program up to three remotes during the same session. Be sure to press a button on each remote within 5 seconds of the previous one. </font></li> <li><font size="3">Step 8: After all remotes have been programmed and confirmed, turn the ignition switch to the LOCK (0) position. This exits programming mode and saves the programmed remotes. </font></li> <li><font size="3">Step 9: Test each remote individually. Verify that all programmed remotes can successfully lock, unlock, and, if equipped, activate additional features such as rear hatch or panic functions. </font></li> </ul> <p><font size="3"><b>Additional Tips:</b> </font></p> <ul> <li><font size="3">Do not remove the key from the ignition at any point during programming. Keep all remotes nearby and ready to use before beginning the procedure. If the door locks do not cycle as expected, turn the ignition to LOCK (0) and restart the process from the beginning.</font></li> </ul>
