<h1>Keyless Entry Remote Programming Instructions – 1999 Honda Prelude</h1> <p><font size="3"><b>Important Note:</b> When programming mode is activated, all previously stored remotes will be erased. To restore full functionality, all remotes you wish to use must be reprogrammed during the same session. Each step must be completed within 5 seconds of the previous one to prevent the system from exiting programming mode. </font></p> <p><font size="3"><b>Step-by-Step Programming Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON (II) position. (This is the position just before the engine starts.) </font></li> <li><font size="3">Step 2: Press either the LOCK or UNLOCK button on the remote you wish to program. A new, unprogrammed remote can also be used for this step. </font></li> <li><font size="3">Step 3: Turn the ignition back to the OFF (0) position. </font></li> <li><font size="3">Step 4: Repeat steps 1 through 3 two more times, for a total of three full cycles, using the same remote each time. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition switch to the ON (II) position again. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote. If successful, the door locks will cycle to confirm the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote you wish to program. The locks should cycle after each remote is accepted by the system. </font></li> <li><font size="3">Step 8: Turn the ignition switch to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test all remotes to confirm proper operation.</font></li> </ul>
