Programming Instructions for the 2000 Acura CL Keyless Entry Remote Fob

Important: This vehicle supports onboard programming. Follow the steps below to program up to three remote fobs.

Step-by-Step Programming Instructions:

• Step 1: Insert the key into the ignition and turn it to the ON (II) position.
• Step 2: Within 1 to 4 seconds, press the lock or unlock button on the remote while aiming it at the keyless entry receiver (typically located near the steering column).
• Step 3: Within 1 to 4 seconds, turn the ignition switch to the OFF position.
• Step 4: Within 1 to 4 seconds, turn the ignition switch back to the ON (II) position.
• Step 5: Within 1 to 4 seconds, press the lock or unlock button on the remote again, aiming at the receiver.
• Step 6: Within 1 to 4 seconds, turn the ignition switch to the OFF position.
• Step 7: Within 4 seconds, turn the ignition switch to the ON (II) position.
• Step 8: Within 1 to 4 seconds, press the lock or unlock button again.
• Step 9: Within 4 seconds, turn the ignition switch to the OFF position.
• Step 10: Within 4 seconds, turn the ignition switch back to the ON (II) position.
• Step 11: Within 1 to 4 seconds, press the lock or unlock button once more.
• Step 12: Listen for the sound of the door lock actuators cycling, indicating the vehicle has entered programming mode. Then, within 1 to 4 seconds, press the lock or unlock button again.
• Step 13: Within 10 seconds, program additional remotes (up to three total) by pointing each one at the receiver and pressing the lock or unlock button. The door locks should cycle to confirm each code is stored.
• Step 14: Turn the ignition switch to the OFF position and remove the key.
• Step 15: Test each remote to verify successful programming.