<h1>Programming Instructions for 2000 TL Keyless Entry Remote Fob</h1> <p><font size="3"><b>Important Information:</b> When entering programming mode, all previously stored remotes will be erased. You must reprogram all remotes during the same session. Each step must be completed within 4 seconds of the previous step to remain in programming mode. Additional remotes must be programmed within 10 seconds of each other. </font></p> <p><font size="3"><b>Step-by-Step Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. </font></li> <li><font size="3">Step 2: Within 4 seconds, press the LOCK or UNLOCK button on one of the remotes. (Either a new or already-programmed remote may be used.) </font></li> <li><font size="3">Step 3: Within 4 seconds, turn the ignition switch to the OFF (0) position.</font></li> <li><font size="3"> Step 4: Within 4 seconds, turn the ignition switch back to ON (II). </font></li> <li><font size="3">Step 5: Repeat Steps 2 through 4 two more times, using the same remote each time. </font></li> <li><font size="3">Step 6: Within 4 seconds, press the LOCK or UNLOCK button on the same remote once more. The door locks should cycle, confirming that the system is now in programming mode. </font></li> <li><font size="3">Step 7: Within 10 seconds, press the LOCK or UNLOCK button again on the same remote to store it. </font></li> <li><font size="3">Step 8: Within 10 seconds of each other, press the LOCK or UNLOCK button on any remaining remotes you want to program. The door locks should cycle after each remote is accepted. </font></li> <li><font size="3">Step 9: Turn the ignition switch to the OFF (0) position to exit programming mode.</font></li> <li><font size="3"> Step 10: Test all programmed remotes to ensure they operate correctly.</font></li> </ul>
