<h1>2000 GMC Safari – Programming Instructions for Remote Fob</h1> <p><font size="3"><b>System Type:</b> Manual Key/Ignition Sequence </font></p> <p><font size="3"><b>Onboard Programming:</b> Supported </font></p> <p><font size="3"><b>Instructions:</b> You can manually program a new key fob by following a specific ignition and door sequence. </font></p> <ul> <li><font size="3">Step 1: Close All Doors: Ensure that all vehicle doors are shut completely. </font></li> <li><font size="3">Step 2: Insert Ignition Key: Do not turn the key yet. </font></li> <li><font size="3">Step 3: Hold UNLOCK Button: On the driver’s door panel, press and hold the power UNLOCK button. Continue to hold until step 9. </font></li> <li><font size="3">Step 4 Ignition Cycle: Turn key to ON (do not start), then back to OFF Repeat: ON → OFF again </font></li> <li><font size="3">Step 5: Release UNLOCK: The door locks will now automatically cycle, confirming entry into programming mode. </font></li> <li><font size="3">Step 6: Program the Remote: Press and hold LOCK and UNLOCK on the fob until the locks cycle. This may take up to 30 seconds. </font></li> <li><font size="3">Step 7: Repeat for Additional Fobs: Program each remote using the same method. </font></li> <li><font size="3">Step 8:Exit Programming: Turn the ignition to ON once more. Remove the key and test all remotes.</font></li> </ul>
