<h1>2000 Honda Accord Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b> Important Notice:</b> Entering programming mode will cancel all previously programmed remotes. You will need to reprogram all remotes once you are in programming mode. Ensure each step is completed within 5 seconds of the previous step to prevent the system from exiting programming mode prematurely. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position, which powers the vehicle’s electronics without starting the engine. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on one of the remotes. (You can use an un-programmed remote for this step if necessary.)</font></li> <li><font size="3"> Step 3: Turn the ignition switch to the LOCK (0) position. This temporarily powers off the vehicle’s electronics, preparing the system for programming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times, using the same remote that was used in Step 2. Make sure to complete each step quickly, within 5 seconds, to keep the system from exiting programming mode.</font></li> <li><font size="3"> Step 5: Turn the ignition switch to the ON (II) position again. This signals the system to enter programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote you used earlier. The power door locks should cycle (lock then unlock), indicating that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote that you wish to program. After pressing each remote’s button, the door locks should cycle, confirming that the system has accepted the remote. </font></li> <li><font size="3">Step 8: Repeat Step 7 for every additional remote. Each remote will trigger the door locks to cycle, confirming that the system has successfully programmed the remote. </font></li> <li><font size="3">Step 9: To exit programming mode, turn the ignition switch to the LOCK (0) position. This will save the programming and prevent further remotes from being added. </font></li> <li><font size="3">Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The power door locks should respond by locking and unlocking, confirming that the remotes are working correctly. </font></li> </ul> <p><font size="3"><b>Note:</b> </font></p> <ul> <li><font size="3">If additional features such as trunk release or panic button need to be programmed, refer to the vehicle's owner’s manual or consult a professional for more specific instructions.</font></li> </ul>
