<h1>Keyless Entry Remote Programming Instructions – 2000 Honda Prelude</h1> <p><font size="3"><b>Important Note:</b> Activating programming mode will erase all previously programmed remotes. To restore full functionality, every remote you intend to use must be reprogrammed during the same session. Each step must be performed within 5 seconds of the previous one to keep the system in programming mode.</font></p> <p><font size="3"><b> Step-by-Step Programming+ Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON (II) position. (This is the position right before the engine starts.) </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on the remote you are using. Note: You can use a remote that hasn't been previously programmed. </font></li> <li><font size="3">Step 3: Turn the ignition switch back to the OFF (0) position. </font></li> <li><font size="3">Step 4: Repeat steps 1 through 3 two additional times (for a total of three full cycles) using the same remote. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition switch to the ON (II) position again. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote. The door locks should automatically cycle, indicating that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: To program additional remotes, press the LOCK or UNLOCK button on each one individually. After each press, the door locks should cycle to confirm that the system has accepted the remote. </font></li> <li><font size="3">Step 8: Once all remotes have been programmed, turn the ignition to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test each remote to ensure it functions correctly with the vehicle.</font></li> </ul>
