2000 Mazda B-Series

Programming Guide for 2000 Mazda B-Series Keyless Entry Remote Fob

Important Notice: This vehicle supports on-board programming for keyless entry remotes. You may program up to two remotes during the same session. Follow the steps exactly as outlined below.

Programming Instructions:

  • Step 1: Make sure all doors are completely closed. Then, open the driver’s door, press the UNLOCK button on the door panel, and leave the door open.
  • Step 2: Insert the key into the ignition.
  • Step 3: Turn the ignition switch from OFF to RUN (the position just before engine starts) eight times within 10 seconds, ending on the eighth turn in the RUN position. The door locks will cycle, indicating the system has entered programming mode.
  • Step 4: Within 20 seconds, press any button on the first remote. The door locks will cycle again, confirming successful programming of the first remote.
  • Step 5: Within the next 20 seconds, press any button on the second remote (if available). The door locks will cycle again, confirming successful programming of the second remote.
  • Step 6: Turn the ignition to the OFF position. The door locks will cycle one final time, signaling that programming mode has ended.