Programming Guide for 2000 Keyless Entry Remote Fob

Important Notice: Programming the keyless entry remote fob requires proper connections and specific steps to be followed. If the programming does not work as expected, you may need professional assistance.

Step-by-Step Programming Instructions:

• Step 1: Locate the Data Port Find the Data Port under the driver’s side dashboard, typically to the right of the steering column.
• Step 2: Insert the Keys into the Ignition Place the vehicle keys into the ignition and leave it in the OFF position.
• Step 3: Verify Metal Contact Pins and Connect the Jumper Wire Ensure that terminals 1 and 4 in the Data Port contain metal contact pins. Use an appropriate jumper wire to connect terminals 1 and 4, and leave the jumper wire in place throughout the programming process. Make sure you are familiar with which terminals are 1 and 4.
• Step 4: Enter Programming Mode Within 10 seconds of connecting the jumper wire, press the Hazard Switch six times. At this point, the doors will automatically lock and unlock once, signaling that the system is in programming mode.
• Step 5: Program the First Remote Press the LOCK button on the transmitter you wish to register three times within 10 seconds. If successful, the doors will lock and unlock once to confirm the programming.
• Step 6: Program Additional Remotes Repeat Step 5 for up to 4 remotes (including any existing remotes) within one minute. After each remote is programmed, the doors will lock and unlock once to confirm successful registration.
• Step 7: Disconnect the Jumper Wire Once all remotes are programmed, disconnect the jumper wire from the Data Port.
• Step 8: Remove the Keys from the Ignition Finally, remove the keys from the ignition to complete the programming process.