2000 Mitsubishi Galant

Programming Guide for 2000 Mitsubishi Galant Keyless Entry Remote Fob

Important Notice: Follow these detailed instructions carefully to program your keyless entry remote fob. Ensure you complete each step in sequence for the process to be successful.

Step-by-Step Instructions:

  • Step 1: Locate the Data Port Find the Data Port under the driver's side dashboard, typically located to the right of the steering column. This is where the jumper wire will need to be connected.
  • Step 2: Insert Keys into the Ignition Insert the vehicle's working key into the ignition and leave it in the OFF position.
  • Step 3: Prepare the Jumper Wire Ensure there are metal contact pins in terminals 1 and 4 of the Data Port. Connect these terminals using a suitable jumper wire. Leave the jumper wire connected throughout the entire programming procedure. Be sure to identify terminals 1 and 4 correctly to avoid errors.
  • Step 4: Activate Programming Mode Within 10 seconds of connecting the jumper wire, press the Hazard Switch six times. The doors will automatically lock and unlock once, indicating that the system has entered programming mode and is ready to accept new remotes.
  • Step 5: Program the First Remote Press the LOCK button on the remote you wish to register three times within 10 seconds. Upon successful programming, the doors will lock and unlock once to confirm that the remote has been registered.
  • Step 6: Program Additional Remotes To program additional remotes (up to 4 total), repeat Step 5 within one minute for each remote. After each successful programming, the doors will lock and unlock once to confirm that the remote has been successfully registered.
  • Step 7: Test the Remotes Test each remote by pressing the lock/unlock buttons to ensure they are functioning properly. If any remote is not working, repeat the programming steps for that remote.
  • Step 8: Disconnect the Jumper Wire Once all remotes have been successfully programmed, disconnect the jumper wire from the Data Port.
  • Step 9: Remove the Keys from the Ignition Finally, remove the keys from the ignition to complete the programming process.