2000 Toyota Avalon

2000 Toyota Avalon Keyless Entry Remote Fob Programming Guide

Important Notice: This vehicle supports onboard programming for keyless entry remotes. No special tools are required, but all steps must be completed accurately and within the specified time limits. Up to four remotes can be programmed.

Programming Procedure:

  • Step 1: Prepare the Vehicle Remove the key from the ignition. Open the driver’s door and leave it open. Ensure all other doors are closed. Make sure the driver’s door is unlocked.
  • Step 2: Insert and Remove the Key Insert the key into the ignition (do not turn it), then immediately remove it.
  • Step 3: Begin First Lock/Unlock Cycle (Within 40 Seconds) A. Using the driver's door power lock switch, perform five lock/unlock cycles, starting with lock. (One cycle = lock, then unlock. Maintain a steady pace of about one cycle per second.) B. Close, then reopen the driver’s door.
  • Step 4: Begin Second Lock/Unlock Cycle (Within 40 Seconds) A. Again, perform five lock/unlock cycles using the driver’s door switch, beginning with lock. B. Insert the key into the ignition. C. Turn the ignition to the ON position (do not start the engine), then turn it OFF. D. Repeat: Turn the ignition to ON, then back to OFF. E. Remove the key from the ignition.
  • Step 5: Confirm Entry Into Programming Mode Within 3 seconds, the door locks should automatically cycle once, indicating the system is in programming mode. If the locks do not cycle, restart the procedure from Step 1.
  • Step 6: Program the Remote(s) (Within 40 Seconds) For each remote: A. Press and hold the lock and unlock buttons simultaneously for 1 second, then release. B. Immediately press and hold the lock button alone for 2 seconds, then release. C. The door locks should cycle once, confirming successful programming. If the locks cycle twice, the remote was not accepted. Repeat steps A and B.
  • Step 7: Finalize Programming Repeat Step 6 for each additional remote. When finished, close the driver’s door to exit programming mode.

Additional Notes:

  • Up to four remotes can be programmed to the vehicle. Each remote must be programmed within the same session. If unsuccessful, restart the procedure and ensure timing is followed precisely.