<h1>2001 Honda Accord Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> Entering programming mode will cancel all previously programmed remotes. After entering programming mode, all remotes must be reprogrammed. Be sure to complete each step within 5 seconds of the previous one to prevent the system from exiting programming mode prematurely. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. This activates the vehicle’s electronics without starting the engine. </font></li> <li><font size="3">Step 2: Press and hold the LOCK or UNLOCK button on one of the remotes. (Note: You can use an un-programmed remote for this step if needed.)</font></li> <li><font size="3"> Step 3: Turn the ignition switch to the LOCK (0) position. This temporarily powers down the vehicle’s systems to prepare the vehicle for programming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times, using the same remote that was used in Step 2. Make sure to complete each step quickly, within 5 seconds, to keep the system in programming mode.</font></li> <li><font size="3"> Step 5: Turn the ignition switch to the ON (II) position once again to signal that the vehicle is in programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote used in Step 2. You should hear the power door locks cycle (lock then unlock), indicating that the system is now in programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote you want to program. After each press, the door locks should cycle to confirm the system has accepted the remote. </font></li> <li><font size="3">Step 8: Repeat Step 7 for each additional remote that you need to program. Each time, the door locks will cycle, signaling that the remote has been successfully programmed. </font></li> <li><font size="3">Step 9: Once all desired remotes have been programmed, turn the ignition switch to the LOCK (0) position to exit programming mode. This step finalizes the process and prevents any further remotes from being added. </font></li> <li><font size="3">Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The door locks should respond by locking and unlocking, confirming that the remote has been successfully programmed. </font></li> </ul> <p><font size="3"><b>Note:</b> </font></p> <ul> <li><font size="3">If additional features such as panic button or trunk release need to be programmed, consult your vehicle’s owner’s manual or reach out to a professional for further instructions specific to those features.</font></li> </ul>
