<h1>2001 Honda Civic Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> Entering programming mode will erase all remotes that were previously programmed. You must reprogram all remotes you want to work after entering programming mode. Complete steps 1-12 within 5 seconds of each other to successfully enter programming mode. Each remote must be programmed within 10 seconds of pressing the button in Step 13. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Ensure all doors are unlocked before starting the programming process. </font></li> <li><font size="3">Step 2: Insert the key into the ignition and turn it to the ON (II) position. → This activates the electrical system of the vehicle, without starting the engine.</font></li> <li><font size="3"> Step 3: On the remote you wish to program, press the LOCK or UNLOCK button once. → This sends the first signal to initiate programming.</font></li> <li><font size="3"> Step 4: Turn the ignition to the ACCESSORY (I) or LOCK (0) position. → This temporarily resets the ignition system. </font></li> <li><font size="3">Step 5: Turn the ignition back to the ON (II) position. → Continue moving through each step quickly to maintain programming eligibility. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button again on the same remote used in Step 3. → This reaffirms the remote’s signal to the vehicle’s system. </font></li> <li><font size="3">Step 7: Turn the ignition to ACCESSORY (I) or LOCK (0) again. → Prepare for the next step by cycling the ignition. </font></li> <li><font size="3">Step 8: Turn the ignition back to the ON (II) position again. → Maintain the proper sequence to keep the system in sync.</font></li> <li><font size="3"> Step 9: Press the LOCK or UNLOCK button once again on the same remote. → The vehicle will now register the remote as part of the process. </font></li> <li><font size="3">Step 10: Turn the ignition to ACCESSORY (I) or LOCK (0) to reset the system again. → This step ensures the vehicle’s system is properly ready for the next cycle. </font></li> <li><font size="3">Step 11: Turn the ignition back to the ON (II) position. → You are now preparing the vehicle for the final step to enter programming mode.</font></li> <li><font size="3"> Step 12: Press the LOCK or UNLOCK button on the same remote once again. → The door locks will cycle (lock and unlock) to confirm the system has successfully entered programming mode. </font></li> <li><font size="3">Step 13: To program each additional remote, press the LOCK button on each remote one at a time. → After pressing the button, the door locks will cycle each time, confirming that the remote has been accepted. → You can program up to three remotes in total. </font></li> <li><font size="3">Step 14: Once all remotes are programmed, turn the ignition to the LOCK (0) position. → This will exit the programming mode and save the programming data. </font></li> <li><font size="3">Step 15: Test each remote by pressing the LOCK and UNLOCK buttons. → The vehicle’s door locks should respond by locking and unlocking to confirm that the remotes are working correctly.</font></li> </ul>
