<h1>Keyless Entry Remote Programming – 2001 Honda Prelude</h1> <p><font size="3"><b>System Type Notice:</b> The 2001 Honda Prelude may be equipped with either a Dealer-Installed or Factory-Installed keyless entry system. Please follow the correct set of instructions based on your vehicle’s configuration. A. Dealer-Installed Keyless Entry System </font></p> <p><font size="3"><b>Important Notes:</b> Entering programming mode will erase all previously stored remotes. Be sure to program all remotes during the same session. Each step must be completed within 5 seconds of the previous step to remain in programming mode. </font></p> <p><font size="3"><b>Programming Steps:</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key and turn the ignition to the ON (II) position. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on the remote. A previously unprogrammed remote may be used. </font></li> <li><font size="3">Step 3: Turn the ignition to the OFF (0) position. </font></li> <li><font size="3">Step 4: Repeat steps 1 through 3 two more times, for a total of three complete cycles using the same remote. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition to the ON (II) position again. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote. The door locks should cycle, indicating that the system is now in programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote. The door locks should cycle after each one is successfully programmed. </font></li> <li><font size="3">Step 8: Turn the ignition to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test each remote to confirm proper function. B. Factory-Installed Keyless Entry System </font></li> </ul> <p><font size="3"><b>Important Notes:</b> This system can store a maximum of three remotes. If a fourth is programmed, the earliest one will be erased. Complete each step within 4 seconds of the previous step. Aim the remote at the receiver near the glove box during programming. </font></p> <p><b><font size="3">Programming Steps:</font></b></p> <ul> <li><font size="3"> Step 1: Turn the ignition to the ON (II) position. </font></li> <li><font size="3">Step 2: Within 4 seconds, press the LOCK or UNLOCK button on the remote. (Ensure you are pointing the remote at the receiver.) </font></li> <li><font size="3">Step 3: Within 4 seconds, turn the ignition to the OFF (0) position. </font></li> <li><font size="3">Step 4: Repeat steps 1 through 3 two more times using the same remote. </font></li> <li><font size="3">Step 5: Within 4 seconds, turn the ignition to the ON (II) position. </font></li> <li><font size="3">Step 6: Within 4 seconds, press the LOCK or UNLOCK button on the same remote. The door locks should cycle to confirm you are in programming mode. Press the LOCK or UNLOCK button again to finalize this remote. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote you want to program. The locks should cycle after each one is accepted. </font></li> <li><font size="3">Step 8: Turn the ignition to the OFF (0) position to exit programming mode.</font></li> <li><font size="3">Step 9: Test all remotes to ensure they are functioning correctly.</font></li> </ul>
