<h1>Keyless Entry Remote Programming Instructions – 2001 Honda S2000</h1> <p><font size="3"><b>Important Notes:</b> When entering programming mode, all previously programmed remotes will be erased. You must program all remotes you want to use during the same session. Each step must be completed within 5 seconds of the previous step to maintain programming mode. </font></p> <p><font size="3"><b>Step-by-Step Programming Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON (II) position. (This is the position just before engine start.) </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on the remote you are programming. A new or unprogrammed remote may be used for this step. </font></li> <li><font size="3">Step 3: Turn the ignition to the OFF (0) position. </font></li> <li><font size="3">Step 4: Repeat steps 1 through 3 two additional times using the same remote, for a total of three cycles. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition back to the ON (II) position. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote once more. The door locks should cycle, indicating the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: Program any additional remotes by pressing the LOCK or UNLOCK button on each one. The door locks should cycle after each successful remote programming. </font></li> <li><font size="3">Step 8: Turn the ignition switch to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test each remote to confirm that all functions are working correctly.</font></li> </ul>
