Programming Guide for 2001 Mercury Sable Keyless Entry Remote Fob

Important Notice: The 2001 Mercury Sable allows onboard programming of keyless entry remote fobs using a timed ignition cycle. All remotes must be programmed in the same session. Any remotes not included will need to be reprogrammed.

Programming Instructions:

• Step 1: Sit in the driver’s seat and ensure all doors are securely closed.
• Step 2: Insert the key into the ignition and turn it to the RUN or ACCESSORY (ACC) position. Do not start the engine.
• Step 3: Within 10 seconds, turn the ignition key from the OFF position to the RUN position eight times, ending the eighth cycle in the RUN position. Ensure the ignition cycles are quick and smooth. Upon successful entry into programming mode, the door locks will cycle (lock and unlock) to confirm the system is ready for remote programming.
• Step 4: Within 20 seconds, press any button on the first keyless remote fob. The door locks will cycle again to confirm successful programming of the first remote.
• Step 5: If you are programming a second keyless remote fob, press any button on it within 20 seconds of programming the first remote. The door locks will cycle again to confirm that the second remote has been successfully programmed.
• Step 6: After all remotes have been programmed, turn the ignition key to the OFF position.
• Step 7: The door locks will cycle one final time, signaling the end of the programming session.
• Step 8: Remove the key from the ignition and test each remote to ensure that the lock and unlock functions are working properly.

Additional Considerations: All remotes must be programmed during the same session. Any remote not included will no longer function until reprogrammed. Timing is critical. Press the remote buttons promptly to avoid the system exiting programming mode. Ensure each remote’s battery is in good condition before starting to avoid programming failures.