2001 Toyota Celica

2001 Toyota Celica Keyless Entry Remote Fob Programming Instructions

Important Notice: The 2001 Toyota Celica allows onboard programming of keyless entry remotes. Each step must be followed precisely and within the required timing for successful setup.

Programming Procedure:

  • Step 1: Vehicle Preparation Ensure the key is removed from the ignition. Open the driver’s door and leave it open. Make sure all other doors are closed, and the driver’s door is unlocked.
  • Step 2: Key Insertion Sequence (Complete Within 5 Seconds) A. Insert the key into the ignition (do not turn it), then remove it. B. Repeat: Insert the key again (do not turn it), then remove it.
  • Step 3: Door Cycle and Key Insert (Complete Within 40 Seconds) A. Close, then reopen the driver’s door. B. Repeat: Close and reopen the driver’s door again. C. Insert the key into the ignition (do not turn it), then remove it.
  • Step 4: Final Door and Ignition Steps (Complete Within 40 Seconds) A. Close and reopen the driver’s door. B. Repeat: Close and reopen the driver’s door again. C. Insert the key into the ignition and leave it in place. D. Close the driver’s door. E. Turn the ignition to the ON position (do not start the engine), then turn it OFF. F. Remove the key from the ignition.
  • Step 5: Enter Programming Mode Within 3 seconds, the door locks should automatically lock and unlock to confirm the vehicle is in programming mode. If this does not occur, restart the procedure from Step 1.
  • Step 6: Program the Remote(s) (Complete Within 40 Seconds) A. Press and hold the lock and unlock buttons on the remote simultaneously for 1.5 seconds, then release. B. Immediately press and hold the lock button for 2 seconds, then release. If successful, the door locks will lock and unlock once. If the locks cycle twice, the remote was not accepted—repeat steps A and B. C. Repeat this process for each additional remote.
  • Step 7: Exit Programming Mode Open the driver’s door to finalize the procedure.