<h1>Remote Programming Guide for 2002 TL Keyless Entry Fob</h1> <p><font size="3"><b>Important:</b> Entering programming mode will erase all previously stored remotes. Be sure to program all desired remotes during the same session. Each step must be completed within 4 seconds of the previous step to prevent the system from exiting programming mode. Any additional remotes must be programmed within 10 seconds of each other. </font></p> <p><font size="3"><b>Step-by-Step Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. </font></li> <li><font size="3">Step 2: Within 4 seconds, press the LOCK or UNLOCK button on one remote. (A new or previously programmed remote may be used.) </font></li> <li><font size="3">Step 3: Within 4 seconds, turn the ignition switch to the OFF (0) position. </font></li> <li><font size="3">Step 4: Within 4 seconds, return the ignition switch to the ON (II) position. </font></li> <li><font size="3">Step 5: Repeat Steps 2 through 4 two more times using the same remote. </font></li> <li><font size="3">Step 6: Within 4 seconds, press the LOCK or UNLOCK button on the same remote again. The power door locks should cycle, confirming the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: Within 10 seconds, press the LOCK or UNLOCK button once more on the same remote to store it. </font></li> <li><font size="3">Step 8: Within 10 seconds of each other, press the LOCK or UNLOCK button on any additional remotes to be programmed. The locks should cycle to confirm that each remote has been successfully stored. </font></li> <li><font size="3">Step 9: Turn the ignition switch to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 10: Test all remotes to confirm they function properly.</font></li> </ul>
