<h1>2002 Honda CR-V – Keyless Entry Remote Fob Programming Instructions Important</h1> <p><font size="3"><b>Notice:</b> Entering programming mode will erase all previously programmed remotes. If you want any existing remotes to continue functioning, you must reprogram all of them during the same session. Additionally, to stay in programming mode, each step must be completed within 5 seconds of the previous step. Waiting too long between steps will cancel the process and require you to start over. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Insert your key into the ignition switch. Turn the ignition to the ON (II) position. Do not start the engine—just activate the electrical system. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on any one of the remotes. This begins the process of remote recognition. You may use a new or unprogrammed remote at this step. </font></li> <li><font size="3">Step 3: Turn the ignition switch to the LOCK (0) position. This completes one cycle of the programming sequence. </font></li> <li><font size="3">Step 4: Repeat Steps 1 through 3 two more times using the same remote. You should perform a total of three full cycles, completing each one within 5 seconds of the last. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition switch to the ON (II) position once again. You are now ready to enter programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote used during the previous steps. If done correctly, the power door locks will cycle (lock then unlock), confirming that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: Now, press the LOCK or UNLOCK button on each remote you wish to program. Wait for the door locks to cycle after each remote is pressed—this is your confirmation that the system has accepted the remote. Be sure to program all remotes during this session. Any remote not included in this step will be erased from the system. </font></li> <li><font size="3">Step 8: Once all remotes have been programmed, turn the ignition switch to the LOCK (0) position. This will exit programming mode and save all programmed data. </font></li> <li><font size="3">Step 9: Remove the key and test all remotes. Verify that each remote can lock, unlock, and perform any additional functions your model supports. </font></li> </ul> <p><font size="3"><b>Tips for Best Results:</b> </font></p> <ul> <li><font size="3">Keep all remotes close by before beginning the process. Maintain a steady rhythm and complete each step within the 5-second window. If the locks don’t cycle at Step 6, restart the process from Step 1.</font></li> </ul>
