<h1>Keyless Entry Remote Programming Instructions – 2002 Honda S2000</h1> <p><font size="3"><b> Important Notes:</b> Entering programming mode erases all previously stored remotes. You must program all remotes you wish to use during the same session. Each step must be completed within 5 seconds of the previous step to remain in programming mode. </font></p> <p><font size="3"><b>Step-by-Step Programming Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON (II) position. (This is the position right before engine start.) </font></li> <li><font size="3">Step 2: Press either the LOCK or UNLOCK button on the remote. You may use a new, unprogrammed remote for this step. </font></li> <li><font size="3">Step 3: Turn the ignition back to the OFF (0) position. </font></li> <li><font size="3">Step 4: Repeat steps 1 through 3 two more times, using the same remote. (This makes a total of three complete ON–press–OFF cycles.) </font></li> <li><font size="3">Step 5: On the third cycle, turn the ignition to the ON (II) position again. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button once more on the same remote. The door locks should cycle, confirming that the system is in programming mode. </font></li> <li><font size="3">Step 7: To program additional remotes, press the LOCK or UNLOCK button on each one. The door locks should cycle after each remote is successfully registered. </font></li> <li><font size="3">Step 8: Once all remotes have been programmed, turn the ignition to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test each remote to ensure all functions operate correctly.</font></li> </ul>
