<h1>2002 Lincoln Blackwood Keyless Entry Remote Fob</h1> <p><font size="3"><b>Important:</b> Make sure all doors are closed and unlocked before beginning. Use the power door lock switch on the driver’s door panel to unlock the vehicle. All remotes must be programmed during the same session. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Sit in the driver’s seat and ensure all vehicle doors are fully closed. </font></li> <li><font size="3">Step 2: Use the power door lock switch on the driver’s door to unlock all doors. </font></li> <li><font size="3">Step 3: Insert the ignition key into the ignition cylinder. </font></li> <li><font size="3">Step 4: Turn the key from the OFF position to the RUN position (do not start the engine) eight times within 10 seconds, ending in the RUN position on the eighth turn. Note: If performed correctly, the door locks will automatically cycle (lock and unlock) once to indicate the vehicle has entered programming mode. </font></li> <li><font size="3">Step 5: Within 20 seconds, press any button on the first remote fob you wish to program. The door locks will cycle to confirm successful programming. </font></li> <li><font size="3">Step 6: Within 20 seconds, press any button on the second remote fob, if applicable. The locks will cycle again to confirm programming of the additional remote. </font></li> <li><font size="3">Step 7: Repeat this step for any additional remotes. Up to four remotes can be programmed during a single session. </font></li> <li><font size="3">Step 8: Turn the ignition to the OFF position to exit programming mode. The door locks will cycle one final time to indicate programming is complete. </font></li> <li><font size="3">Step 9: Remove the key from the ignition. </font></li> <li><font size="3">Step 10: Test each programmed remote fob to ensure all functions work as expected, including locking and unlocking the vehicle.</font></li> </ul>
