2002 Lincoln Navigator

<h1>Programming a Keyless Entry Remote for 2002 Navigator – Step-by-Step Guide</h1> Important: This procedure enables you to program keyless entry remote fobs for your 2002 Navigator using the vehicle’s built-in programming system. All remotes must be programmed during the same session—any remotes not included will be erased from memory. Have all remotes prepared before starting. Timing is essential—complete steps promptly and in sequence. If programming fails, restart the process from the beginning. Review the full instructions before beginning. Remote Fob Programming Steps: <ul> <li>Step 1: Make sure all vehicle doors are closed. </li> <li>Step 2: Open the driver’s door and leave it open throughout the procedure. </li> <li>Step 3: Press and hold the UNLOCK button on the driver’s door panel. </li> <li>Step 4: While holding the unlock button, insert the key into the ignition. </li> <li>Step 5: Turn the ignition from OFF to RUN (do not start the engine). </li> <li>Step 6: Repeat the OFF to RUN cycle eight times within 10 seconds, ending in the RUN position on the 8th turn. </li> <li>Step 7: The door locks will cycle (lock and unlock) to confirm that the vehicle is in programming mode. </li> <li>Step 8: Release the unlock button. </li> <li>Step 9: Within 20 seconds, press any button on the first remote fob. </li> <li>Step 10: The door locks will cycle to confirm the remote has been successfully programmed. </li> <li>Step 11: Within 20 seconds, press any button on the second remote fob, if applicable. </li> <li>Step 12: The door locks will cycle again to confirm programming of the second remote. </li> <li>Step 13: Repeat for any additional remotes, as needed (up to the vehicle’s system limit). </li> <li>Step 14: Turn the ignition to the OFF position. </li> <li>Step 15: The door locks will cycle one final time to indicate the end of programming mode.</li> </ul>

2002 Lincoln Navigator

Join our newsletter