2002 Mitsubishi Galant

Programming Guide for 2002 Mitsubishi Galant Keyless Entry Remote Fob

Important Notice: Follow these detailed instructions to ensure that your keyless entry remote fob is programmed successfully. Each step should be followed carefully to guarantee proper functionality.

Step-by-Step Instructions:

  • Step 1: Locate the Data Port Find the Data Port under the driver's side dashboard, typically located to the right of the steering column. This is where you'll connect the jumper wire to initiate the programming process.
  • Step 2: Insert Keys into the Ignition Insert your vehicle's working key into the ignition and leave the ignition in the OFF position.
  • Step 3: Ensure Metal Contact Pins in Terminals 1 and 4 Check that there are metal contact pins in terminals 1 and 4 of the Data Port. These terminals need to be connected to start the programming.
  • Step 4: Connect the Jumper Wire Connect the jumper wire to terminals 1 and 4 in the Data Port. Keep the jumper wire connected throughout the entire programming procedure. Be sure to properly identify the correct terminals to avoid errors.
  • Step 5: Activate Programming Mode Within 10 seconds of connecting the jumper wire, press the Hazard Switch six times in quick succession. The doors will automatically lock and unlock once, indicating that the system has entered programming mode.
  • Step 6: Program the First Remote Press the LOCK button on the remote you want to register three times within 10 seconds. Upon successful programming, the doors will lock and unlock once to confirm that the remote has been successfully registered.
  • Step 7: Test the First Remote Test the remote by pressing the lock/unlock buttons to verify that it works with your vehicle. If it doesn't work, repeat Step 6.
  • Step 8: Program Additional Remotes If you have additional remotes (up to 4 remotes total), repeat Step 6 within one minute for each additional remote. After programming each remote, the doors will lock and unlock once to confirm successful registration.
  • Step 9: Test All Remotes Once all remotes have been programmed, test each one to ensure that the lock/unlock functions are working properly.
  • Step 10: Disconnect the Jumper Wire Once all remotes are successfully programmed, disconnect the jumper wire from the Data Port to exit programming mode.
  • Step 11: Turn the Ignition to OFF Turn the ignition to the OFF position, if it hasn't been done yet, to complete the process.
  • Step 12: Remove Keys from the Ignition Finally, remove the keys from the ignition to complete the programming process. Verify that all remotes are functioning before concluding.