2002 Mitsubishi Lancer

Programming Guide for 2002 Mitsubishi Lancer Keyless Entry Remote Fob

Important Notice: Carefully follow these instructions to program your keyless entry remote fob. Ensure each step is completed in sequence to guarantee successful programming.

Step-by-Step Programming Instructions:

  • Step 1: Locate the Data Port Find the Data Port under the driver’s side dashboard, usually located to the right of the steering column. This is where you will connect the jumper wire.
  • Step 2: Insert Keys into the Ignition Insert the keys into the ignition and leave the ignition in the OFF position.
  • Step 3: Ensure Metal Contact Pins in Terminals 1 and 4 Verify that there are metal contact pins in terminals 1 and 4 of the Data Port. These terminals are necessary to begin the programming process.
  • Step 4: Connect the Jumper Wire Use a suitable jumper wire to connect terminals 1 and 4 in the Data Port. Keep the jumper wire connected throughout the entire programming procedure. Ensure the wire is securely in place.
  • Step 5: Activate Programming Mode Within 10 seconds of connecting the jumper wire, press the Hazard Switch six times in quick succession. The doors will automatically lock and unlock once, indicating that the system is in programming mode.
  • Step 6: Program the First Remote Press the LOCK button on the remote you wish to register three times within 10 seconds. The doors will lock and unlock once to confirm that the remote has been successfully programmed.
  • Step 7: Program Additional Remotes Repeat Step 6 for any additional remotes (up to 4 remotes total) within one minute. After programming each remote, the doors will lock and unlock once to confirm successful registration.
  • Step 8: Test All Remotes After programming all remotes, test each one by pressing the lock/unlock buttons to ensure proper functionality.
  • Step 9: Disconnect the Jumper Wire Once all remotes have been successfully programmed, disconnect the jumper wire from the Data Port.
  • Step 10: Turn the Ignition OFF Make sure the ignition is turned to the OFF position after disconnecting the jumper wire.
  • Step 11: Remove Keys from the Ignition Finally, remove the keys from the ignition and verify that all remotes are functioning properly.