<h1>2003 Acura RL Remote Keyless Entry Fob Programming Instructions</h1> <p><font size="3"><b>Important:</b> All remotes (up to 3 total) must be present during the programming process. Any remote not programmed during this session will no longer function. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions :</b> Steps 1–12 are completed using one remote. Step 13 must be completed for each remote you want to program. </font></p> <ul> <li><font size="3">Step 1: Enter the vehicle, close all doors, and make sure they are unlocked. </font></li> <li><font size="3">Step 2: Insert the key and turn the ignition to the ON (II) position. Do not start the engine. </font></li> <li><font size="3">Step 3: Press the LOCK button on the remote. </font></li> <li><font size="3">Step 4: Turn the key to the ACCESSORY (I) position (radio should turn on in this mode).</font></li> <li><font size="3"> Step 5: Turn the ignition back to the ON (II) position. </font></li> <li><font size="3">Step 6: Press the LOCK button again on the remote. </font></li> <li><font size="3">Step 7: Turn the key to the ACCESSORY (I) position.</font></li> <li><font size="3"> Step 8: Turn the ignition back to the ON (II) position. </font></li> <li><font size="3">Step 9: Press the LOCK button again on the remote. </font></li> <li><font size="3">Step 10: Turn the key to the ACCESSORY (I) position once more. </font></li> <li><font size="3">Step 11: Turn the ignition to the ON (II) position again. </font></li> <li><font size="3">Step 12: Press the LOCK button. The door locks should chirp or cycle, indicating the system has entered programming mode. </font></li> <li><font size="3">Step 13: Press the LOCK button on each remote you want to program (including the one used to initiate the process). The locks should cycle after each successful input. </font></li> <li><font size="3">Step 14: Turn the ignition to the OFF position and remove the key. Test all remotes to confirm they lock and unlock the doors properly. Optional: Enable or Disable Chirp Confirmation This feature allows you to toggle the audible lock/unlock chirp for each remote. </font></li> <li><font size="3">Step 1: Press and hold the trunk release button on the remote. </font></li> <li><font size="3">Step 2: While holding the trunk button, press and hold the LOCK button. </font></li> <li><font size="3">Step 3: Wait for the remote’s LED to flicker for about one second, then release both buttons. </font></li> <li><font size="3">Step 4: Test the remote. This procedure toggles the chirp sound on or off. Note: Repeat this process for each remote individually. Chirp settings must be programmed per remote.</font></li> </ul>
