<h1>Remote Fob Programming Instructions for 2003 TL</h1> <p><font size="3"><b>Important Notes:</b> Entering programming mode will erase all previously stored remotes. Be prepared to reprogram all remotes during the same session. Each step must be completed within 4 seconds of the previous step to prevent the system from exiting programming mode. Additional remotes must be programmed within 10 seconds of each other. </font></p> <p><font size="3"><b>Step-by-Step Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. </font></li> <li><font size="3">Step 2: Within 4 seconds, press the LOCK or UNLOCK button on any remote. (A new or existing remote may be used.) </font></li> <li><font size="3">Step 3: Within 4 seconds, turn the ignition switch to the OFF (0) position.</font></li> <li><font size="3"> Step 4: Within 4 seconds, return the ignition switch to the ON (II) position. </font></li> <li><font size="3">Step 5: Repeat Steps 2 through 4 two additional times, using the same remote each time. </font></li> <li><font size="3">Step 6: Within 4 seconds, press the LOCK or UNLOCK button again on the same remote. The door locks should cycle, confirming that the system has entered programming mode. </font></li> <li><font size="3">Step 7: Within 10 seconds, press the LOCK or UNLOCK button once more on the same remote to program it. </font></li> <li><font size="3">Step 8: Within 10 seconds of each other, press the LOCK or UNLOCK button on any additional remotes. The locks should cycle each time a remote is successfully programmed. </font></li> <li><font size="3">Step 9: Turn the ignition switch to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 10: Test all remotes to confirm proper functionality.</font></li> </ul>
