<h1>2003 Honda Element – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Note:</b> When entering programming mode, the vehicle will erase all previously stored remote codes. This means you must program all remotes you intend to use during the same session. Additionally, each step must be completed within 5 seconds of the previous one to avoid automatically exiting programming mode.</font></p> <p><b><font size="3"> Programming Procedure:</font></b></p> <ul> <li><font size="3"> Step 1: Insert the key into the ignition cylinder and turn it to the ON (II) position. The dashboard lights will illuminate, but do not start the engine. </font></li> <li><font size="3">Step 2: Within 5 seconds, press either the LOCK or UNLOCK button on the remote you wish to program. It’s acceptable to use a brand-new or previously unprogrammed remote for this step. </font></li> <li><font size="3">Step 3: Turn the ignition switch back to the LOCK (0) position. This completes one programming cycle. </font></li> <li><font size="3">Step 4: Repeat Steps 1 through 3 two more times using the same remote. You should complete three full ON → button press → OFF cycles in total. Be sure to move quickly through each cycle—timing is critical. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition to the ON (II) position again. You are now in remote programming mode. </font></li> <li><font size="3">Step 6: Press either the LOCK or UNLOCK button on the same remote again. The door locks will cycle (lock and unlock automatically), confirming the system is ready to accept remote codes. </font></li> <li><font size="3">Step 7: Within 5 seconds of the locks cycling, press the LOCK or UNLOCK button on any remote you want to program. The door locks should cycle again to confirm that each remote has been successfully registered. </font></li> <li><font size="3">Step 8: Repeat Step 7 for each additional remote you wish to program. Wait for the locks to cycle after each remote to verify successful programming. </font></li> <li><font size="3">Step 9: Once all remotes have been programmed, turn the ignition to the LOCK (0) position. This will exit the programming mode and save the remote codes to memory. </font></li> <li><font size="3">Step 10: Test each remote by locking and unlocking the vehicle doors. Confirm all programmed remotes operate properly before closing out the session. </font></li> </ul> <p><font size="3"><b>Additional Tips:</b> </font></p> <ul> <li><font size="3">Do not remove the key from the ignition until all steps are completed. If the door locks do not cycle, you may need to start the process over. Ensure the vehicle battery is fully charged before beginning to avoid signal issues during programming.</font></li> </ul>
