<h1>Keyless Entry Remote Programming Instructions – 2003 Honda S2000</h1> <p><font size="3"><b>Important Notes:</b> Entering programming mode will erase all remotes previously paired with the system. You must reprogram all remotes you intend to use during this session. Each step must be completed within 5 seconds of the previous one to keep the system in programming mode. </font></p> <p><font size="3"><b>Step-by-Step Programming Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Insert your key into the ignition and turn it to the ON (II) position. (This is the position just before the engine starts.) </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on the remote you wish to program. A remote that hasn’t been programmed before may also be used. </font></li> <li><font size="3">Step 3: Turn the ignition back to the OFF (0) position.</font></li> <li><font size="3"> Step 4: Repeat steps 1 through 3 two more times using the same remote. (You will complete three total ON–press–OFF cycles.) </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition to the ON (II) position once again. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote. The door locks should cycle, confirming that you have entered programming mode. </font></li> <li><font size="3">Step 7: For each additional remote, press the LOCK or UNLOCK button. The door locks should cycle after each successful programming. </font></li> <li><font size="3">Step 8: When finished, turn the ignition to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test all remotes to ensure they operate the vehicle correctly.</font></li> </ul>
