<h1>2004 Acura RL Remote Keyless Entry Fob Programming Instructions</h1> <p><font size="3"><b>Important:</b> All remotes to be programmed (up to 3) must be present at the time of programming. Any remote not included during this process will be erased from the system and will no longer function.</font></p> <p><font size="3"><b> Step-by-Step Programming Instructions:</b> Steps 1–12 are performed using one remote. Step 13 must be completed for each remote you wish to program. </font></p> <ul> <li><font size="3">Step 1: Enter the vehicle, close all doors, and ensure they are unlocked. </font></li> <li><font size="3">Step 2: Insert the key and turn the ignition to the ON (II) position (do not start the engine).</font></li> <li><font size="3"> Step 3: Press the LOCK button on the remote. </font></li> <li><font size="3">Step 4: Turn the key to the ACCESSORY (I) position (radio should power on). </font></li> <li><font size="3">Step 5: Turn the ignition back to the ON (II) position. </font></li> <li><font size="3">Step 6: Press the LOCK button again.</font></li> <li><font size="3">Step 7: Turn the key to the ACCESSORY (I) position. </font></li> <li><font size="3">Step 8: Turn the ignition to the ON (II) position. </font></li> <li><font size="3">Step 9: Press the LOCK button again. </font></li> <li><font size="3">Step 10: Turn the key to the ACCESSORY (I) position. </font></li> <li><font size="3">Step 11: Turn the ignition to the ON (II) position one final time.</font></li> <li><font size="3"> Step 12: Press the LOCK button. The door locks should chirp or cycle, indicating the vehicle has entered programming mode.</font></li> <li><font size="3"> Step 13: Press the LOCK button on each remote to be programmed, including the original one used in Steps 1–12. The locks will chirp after each successful programming.</font></li> <li><font size="3"> Step 14: Turn the ignition to the OFF position and remove the key. Test each remote to ensure it locks and unlocks the doors correctly. Optional: Enable or Disable Chirp Confirmation This procedure allows you to toggle the audible chirp sound when locking or unlocking with the remote.</font></li> <li><font size="3"> Step 1: Press and hold the trunk release button on the remote.</font></li> <li><font size="3"> Step 2: While holding the trunk button, press and hold the LOCK button. </font></li> <li><font size="3">Step 3: Wait for the LED on the remote to flicker for about 1 second, then release both buttons. </font></li> <li><font size="3">Step 4: Test the remote. This action toggles the chirp on or off. Note: Chirp settings are stored per remote. Repeat this procedure on each remote if you want consistent behavior across all units.</font></li> </ul>
