<h1>Remote Programming Instructions for 2004 TL Keyless Entry Fob</h1> <p><font size="3"><b>Important Notice:</b> When programming begins, all previously stored remotes will be erased. Be sure to program all remotes during the same session. Each step must be completed within 4 seconds of the previous step to avoid exiting programming mode. Additional remotes must be programmed within 10 seconds of one another. </font></p> <p><font size="3"><b>Step-by-Step Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. </font></li> <li><font size="3">Step 2: Within 4 seconds, press the LOCK or UNLOCK button on any remote. (This can be a new or previously programmed remote.) </font></li> <li><font size="3">Step 3: Within 4 seconds, turn the ignition switch to the OFF (0) position. </font></li> <li><font size="3">Step 4: Within 4 seconds, return the ignition to the ON (II) position. </font></li> <li><font size="3">Step 5: Repeat Steps 2 through 4 two more times using the same remote. </font></li> <li><font size="3">Step 6: Within 4 seconds, press the LOCK or UNLOCK button once more on the same remote. The power door locks should cycle, confirming the system has entered programming mode. </font></li> <li><font size="3">Step 7: Within 10 seconds, press the LOCK or UNLOCK button again on the same remote to program it. </font></li> <li><font size="3">Step 8: Within 10 seconds of each other, press the LOCK or UNLOCK button on any additional remotes to be programmed. The door locks should cycle to confirm each remote is accepted. </font></li> <li><font size="3">Step 9: Turn the ignition switch to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 10: Test all remotes to verify correct operation.</font></li> </ul>
