<h1>2004 Honda Accord Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> Entering programming mode will erase all previously programmed remotes. After entering programming mode, you must reprogram all remotes. Be sure to complete each step within 5 seconds of the previous one to prevent the system from exiting programming mode prematurely. </font></p> <p><font size="3"><b>Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Turn the ignition switch to the ON (II) position. This activates the vehicle’s electronics without starting the engine. </font></li> <li><font size="3">Step 2: Press the LOCK or UNLOCK button on one of the remotes. (An un-programmed remote can be used for this step if necessary.) </font></li> <li><font size="3">Step 3: Turn the ignition switch to the LOCK (0) position. This temporarily powers off the vehicle’s systems to prepare the system for reprogramming. </font></li> <li><font size="3">Step 4: Repeat Steps 1, 2, and 3 two more times, using the same remote as in Step 2. Make sure to complete each step within 5 seconds to prevent the system from exiting programming mode. </font></li> <li><font size="3">Step 5: Turn the ignition switch to the ON (II) position once again. This will put the vehicle into programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote you used in Step 2. The power door locks should cycle (lock then unlock) to confirm that the vehicle is now in programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each remote you wish to program. After pressing each button, the door locks should cycle again to confirm that the system has accepted the remote.</font></li> <li><font size="3"> Step 8: Repeat Step 7 for each additional remote that you wish to program. Each time you press the remote button, the door locks will cycle, confirming that the system has successfully learned the remote. </font></li> <li><font size="3">Step 9: Once all remotes are programmed, turn the ignition switch to the LOCK (0) position to exit programming mode. This saves the programming data and prevents any further remotes from being added. </font></li> <li><font size="3">Step 10: Test each remote by pressing the LOCK and UNLOCK buttons. The door locks should respond by locking and unlocking, confirming that the remotes have been successfully programmed. </font></li> </ul> <p><font size="3"><b>Note:</b> </font></p> <ul> <li><font size="3">Remote Head Key Programming: If your vehicle uses a Remote Head Key, you can use the instructions above to program the remote portion of the key. However, the key blade must be cut and programmed by to match the vehicle's ignition system. </font></li> <li><font size="3">Key Cutting and Programming: If you need the key blade portion programmed, please contact a professional who has the necessary equipment to cut and program the key portion.</font></li> </ul>
