<h1>2004 Honda Civic Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b> Important Notice:</b> Entering programming mode will erase all remotes previously programmed to the vehicle. You must reprogram all remotes you want to use once the programming mode is entered. Steps 1–12 must be completed within 5 seconds of each other to successfully enter programming mode. Each remote must be programmed within 10 seconds of pressing the button in Step 13.</font></p> <p><font size="3"> <b>Programming Procedure:</b></font></p> <ul> <li><font size="3"> Step 1: Ensure all doors are unlocked before beginning the programming process. </font></li> <li><font size="3">Step 2: Insert the key into the ignition and turn it to the ON (II) position. → This powers up the electrical systems of the vehicle but does not start the engine. </font></li> <li><font size="3">Step 3: Press the LOCK or UNLOCK button on the remote you wish to program. → This sends the first signal to initiate the programming process. </font></li> <li><font size="3">Step 4: Turn the ignition to the ACCESSORY (I) or LOCK (0) position. → This temporarily resets the ignition system. </font></li> <li><font size="3">Step 5: Turn the ignition back to the ON (II) position. → Continue moving through each step without delay.</font></li> <li><font size="3"> Step 6: Press the LOCK or UNLOCK button again on the same remote used in Step 3. → This reaffirms the remote’s signal to the vehicle’s system. </font></li> <li><font size="3">Step 7: Turn the ignition to ACCESSORY (I) or LOCK (0) again. → This prepares the system for the next signal. </font></li> <li><font size="3">Step 8: Turn the ignition back to the ON (II) position. → This keeps the system in sync with the remote’s signal. </font></li> <li><font size="3">Step 9: Press the LOCK or UNLOCK button again on the same remote. → This final button press confirms the remote for programming.</font></li> <li><font size="3"> Step 10: Turn the ignition to ACCESSORY (I) or LOCK (0) again. → This prepares the system for the last programming signal. </font></li> <li><font size="3">Step 11: Turn the ignition back to the ON (II) position. → This step is the last cycle before entering programming mode. </font></li> <li><font size="3">Step 12: Press the LOCK or UNLOCK button on the same remote again. → The door locks will cycle (lock and unlock), indicating that the system has entered programming mode. </font></li> <li><font size="3">Step 13: To program additional remotes, press the LOCK button on each remote you wish to add. → After pressing the button on each remote, the door locks will cycle to confirm the remote has been accepted. → The system can accept up to three remotes. </font></li> <li><font size="3">Step 14: Once all remotes have been programmed, turn the ignition to the LOCK (0) position. → This exits the programming mode and saves the remote settings. </font></li> <li><font size="3">Step 15: Test each remote by pressing the LOCK and UNLOCK buttons. → The doors should lock and unlock, confirming that the remotes are functioning properly.</font></li> </ul>
