<h1>2004 Honda Element – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Important Notice:</b> When you enter programming mode, all previously programmed remotes will be erased. Any remote you wish to use must be reprogrammed during the same session. Each step must be completed within 5 seconds of the previous one to prevent the system from exiting programming mode. </font></p> <p><font size="3"><b>Programming Steps:</b> </font></p> <ul> <li><font size="3">Step 1: Insert your key into the ignition and turn it to the ON (II) position. The dashboard lights will illuminate, but do not start the engine. </font></li> <li><font size="3">Step 2: Within 5 seconds, press either the LOCK or UNLOCK button on the remote you wish to program. A brand-new or previously unprogrammed remote may be used for this step. </font></li> <li><font size="3">Step 3: Turn the ignition switch to the LOCK (0) position. This completes one programming cycle. </font></li> <li><font size="3">Step 4: Repeat Steps 1 through 3 two more times using the same remote. In total, complete three ON → button press → OFF cycles. Ensure each step is done within 5 seconds of the previous to maintain access to programming mode. </font></li> <li><font size="3">Step 5: After the third cycle, turn the ignition to the ON (II) position again. You should now be in programming mode. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote again. The door locks should cycle automatically (lock then unlock), confirming successful entry into programming mode. </font></li> <li><font size="3">Step 7: Within 5 seconds, press the LOCK or UNLOCK button on each remote you wish to program. After each button press, the door locks will cycle, indicating the system has accepted the remote. </font></li> <li><font size="3">Step 8: Repeat Step 7 for any additional remotes, one at a time. Be sure to wait for the lock cycle after each remote before moving to the next. </font></li> <li><font size="3">Step 9: Turn the ignition switch to the LOCK (0) position to exit programming mode. All programmed remotes should now be stored in the vehicle’s memory. </font></li> <li><font size="3">Step 10: Test each remote by locking and unlocking the doors. Confirm that each one operates all functions correctly. </font></li> </ul> <p><b><font size="3">Additional Tips:</font></b></p> <ul> <li><font size="3"> If the locks do not cycle at any point, restart the process from Step 1. Make sure your vehicle battery is fully charged to prevent programming failure. Do not remove the key from the ignition during the process.</font></li> </ul>
