<h1>Keyless Entry Remote Programming Instructions – 2004 Honda S2000</h1> <p><font size="3"><b>Important Notes:</b> Entering programming mode will erase all previously stored remotes. You must reprogram all remotes you wish to use during the same session. Each step must be completed within 5 seconds of the previous one to keep the system in programming mode. </font></p> <p><font size="3"><b>Step-by-Step Programming Procedure</b> </font></p> <ul> <li><font size="3">Step 1: Insert the key into the ignition and turn it to the ON (II) position. (This is the position just before starting the engine.) </font></li> <li><font size="3">Step 2: Press either the LOCK or UNLOCK button on the remote you wish to program. An unprogrammed remote may also be used for this step. </font></li> <li><font size="3">Step 3: Turn the ignition switch to the OFF (0) position. </font></li> <li><font size="3">Step 4: Repeat steps 1 through 3 two more times using the same remote. (This completes three full cycles.) Step 5: After the third cycle, turn the ignition back to the ON (II) position. </font></li> <li><font size="3">Step 6: Press the LOCK or UNLOCK button on the same remote. The door locks should cycle, confirming that the vehicle has entered programming mode. </font></li> <li><font size="3">Step 7: Press the LOCK or UNLOCK button on each additional remote you want to program. After each press, the door locks should cycle to confirm successful programming. </font></li> <li><font size="3">Step 8: Once all remotes have been programmed, turn the ignition to the OFF (0) position to exit programming mode. </font></li> <li><font size="3">Step 9: Test each remote to ensure proper operation.</font></li> </ul>
