2004 Lincoln Navigator

<h1>Programming a Keyless Entry Remote for 2004 Navigator – Step-by-Step Guide</h1> Important: This procedure is for programming keyless entry remote fobs for a 2004 Navigator. All remotes must be programmed during the same session. If you do not program a remote during this session, it will be erased from the system. Ensure all remotes are ready before starting. Complete each step promptly and in the correct sequence. If the process fails, restart from the beginning. Read through the entire procedure before starting. Remote Fob Programming Steps: <ul> <li>Step 1: Ensure that all vehicle doors are closed. </li> <li>Step 2: Open the driver’s door and leave it open during the entire procedure. </li> <li>Step 3: Press and hold the UNLOCK button on the driver’s door panel. </li> <li>Step 4: While holding the unlock button, insert the key into the ignition. </li> <li>Step 5: Turn the ignition from OFF to RUN (do not start the engine). </li> <li>Step 6: Repeat the OFF to RUN cycle eight times within 10 seconds, ending with the key in the RUN position on the 8th turn. </li> <li>Step 7: The door locks will cycle (lock and unlock) to confirm that the vehicle has entered programming mode. </li> <li>Step 8: Release the unlock button. </li> <li>Step 9: Within 20 seconds, press any button on the first remote fob. </li> <li>Step 10: The door locks will cycle to confirm that the first remote has been successfully programmed. </li> <li>Step 11: Within 20 seconds, press any button on the second remote fob, if applicable. </li> <li>Step 12: The door locks will cycle again to confirm programming of the second remote. </li> <li>Step 13: Repeat for any additional remotes, if needed (up to the vehicle’s system limit). </li> <li>Step 14: Turn the ignition to the OFF position. </li> <li>Step 15: The door locks will cycle one final time to indicate the end of programming mode.</li> </ul>

2004 Lincoln Navigator

Join our newsletter